This is a working on off button. Works with DC and AC.

Contains:
-Hull (Front piece)
-Hull (Back piece)
-Hull connector
-2 springs
-Button (right)
-Button (left)
-Button connector

What is needed:
-5,8 cm of conductive wire with a diameter of 1 mm.
(The kind used in the picture is copper, but any conductive wire should work.)

No

No

The button in the picture was printed in PLA with a layer height of 0,12 mm. No rafts or supports are needed.

Assembly:

Put all of the parts together as shown in the images. The hull can be put together using glue or tape. If the wires are loose, they can be glued in place.