Summary

Snaps into the zig-zag side of a wire rack shelf. Then slide a piece of paper that is 6mm taller than the ClampHeight of the part.

Find the ClampHeight for your shelf

The ClampHeight is the inner distance between the horizontal bars above and below the zig-zag. It is typically 15mm to 18mm for most wire shelves. Eyeballing with a ruler is precise enough as within 0.5mm still snaps the part to the shelf correctly.

Print the right ClampHeight for your shelf

The ClampHeight is engraved into the front of the part. If one of the STL files does not work for you, the customizer on thingiverse... sadly has some issue rendering the cylinders correctly for this part. OpenSCAD, installed with all defaults, renders it without issue. Use the provided WireShelfLabel.scad in OpenSCAD to easily customize ClampHeight.

My Makes

Printed 6 of the 15mm's, 1 of the 15.5mm, and 6 of the 16mm's. After slicing, my gcode mentioned a warning, yet I didn't have issues with the prints.

• Prusa MK4
• PLA filament
• 0.2mm layer height
• No supports used

History

A rebuild based off this model https://www.printables.com/model/869455-wire-shelf-label-holder
Closest alternative I found on thingiverse (doesn't hold paper): https://www.thingiverse.com/thing:4444530