Hi,

All credits go to the original model and its remix. I just cut it in more pieces for easier printing.

I struggled printing the Demogorgon remixed by Geoffro in 230% (biggest I could on my printer).
Base and head, no issue.
But arms were a different story. After few fails, I decided to just cut the arms in 3 pieces each. Now can be printed without support (depending how your printer handles overhangs) or only few.
So you'll a bit of time glueing and sanding, but prints will be much easier and waste less plastic from support material.

on the picture, chair for scale (I'm out of banana). It's 47cm tall)

Creality

CR-10S

No

Doesn't Matter

0,2

10 / 40

10% infill for base, for thinner part and to avoid printing in between infill pattern, I gradually increase the infill up to 40% for the legs (to get strong print).
Head is 15%, arms 10%

No support mandatory. Can help, but your printer might handle without.

glueing + sanding.
I don't how to paint :(