Summary

This is the same dimensions as the original metal LCD support, except it's 1mm thicker.
I have not printed this thicker design yet, the one the original thickness was too thin and broke. The one in the photo has a cutout for a raspberry pi case, this version does not have a cutout.

I printed this with a couple custom supports, but one broke off and that part printed fine, so they probably aren't needed.

I drilled the holes for the LCD screen with a 7/64 bit as they were too tight right off the printer. Next, attach the screen and knob. Then attach the LCD ribbon cable, remember it goes into port 3, the far right if you are looking at the underside of the LCD. Last, attach the LCD support to the frame.