This is a case for the RuiDeng (RD Tech) power supplies that have a separate board (DPH and some higher power models). It will of course work for any similar power supply since the front panels are all the same.

Included full Fusion360 file with lots of user parameters + STEP.
In Fusion you can tweak parameters to change common stuff such as screw sizes, wall thickness, overall width and length. You can customize the rear panel to suit whatever connectors your prefer.

You may prefer more air holes, I use mine just for very low power stuff so I opted for a nicer look with just a top vent over the mosfet. Feel free to remix the cap since you have all the files.

bastardized CR-10

Doesn't Matter

No

200

20

No supports required, the only overhangs have a trick to let them print properly.

You will have to drill or poke through the holes on the top panel, they have 1 full layer to help them print without supports.

I printed mine in PETG in case it ever gets hot, it should print ok in any material.

• 4x screws M3 5mm length
• 4x screws M3 over 25mm length
• 2x XT60 connectors (male)
• 4x banana jack (female) with 3mm screws at the back for mounting, 2 red and 2 black
• 2x DC jack (DC-022 5.5x2.1mm) female
• some wires to tie the input connectors to the board