Original Post:

• This is a remix of the Robust Teaching Clock.
• Gears were updated with spur gears generated by Fusion 360.
• Face updated with two options: inlaid or raised markings.
• Drive gears updated with “D” shaft to ensure proper assembly.
• Assembly alignment dots added to ensure proper gear placement.

Prusa

I3 MK3S

No

No

0.2mm

15% rectilinear

inlaid_minute_marks.stl: Set elephant's foot compensation to zero. Extra marks are included as it is likely some may become dislodged during printing.

The inlaid numbers and marks are superglued in place. I used Stick Fast CA Thin super glue with a 25 ga. blunt tip dispensing needle attached to the bottle.