This is a tool used to prevent the flywheel from spinning during clutch replacement. I designed the part for a 06 BMW 325i with a N52 engine and Getrag 6 speed clutch. I think it will work with most BMW's as they use the same spline count on the flywheel.

The tool is designed to sit over the dowel at the 6-o-clock position and use one of the old aluminum bolts (or any similar object) to hold the tool in place while the flywheel bolts are being torqued.

Included a 0.15" spacer that I ended up not using. This was for any issues with the dowel.

Bambulabs

Bambu X1C

No

No

15%

I printed with PAHT-CF but it's not necessary. Should work fine with PETG or PLA+ with 3-4 walls and 10-25% infill

Designed in NX