Summary

This is a remix of "8Bitdo Ultimate 2C & XBOX Series Controller Stand" by LeoRivals.

All I did was a simple repair to close the defect hole in the side of the model, and removed the 6 indented foot holes in the bottom of the model which were causing large overhangs underneath (2nd picture). This model has an entirely flat base, the original model does not.

Can confirm that it fits in the dock well, not flush against the middle of the dock, but it fits well enough that it doesn't try to shift around at all.

Also ignore the Shaymin logo on the front, that is not present in this and it will come out smooth.

Printed at 0.16mm, 3 wall, 15% infill, 60mm speed, ~8 Hours.