This is a Custom Designed shell, for the Logitech G502 Hero Wired mouse.

The shell can be printed without supports, but be sure to have good bed adhesion, for the two mouse buttons, that need to be printed on their side, to have the most strength.
All Screws, that are used in this build, are contained in the original mouse.

The shell only uses the two mouse buttons. In my version, i have de-soldered all other switches (The 3 Kailh switches + The two middle mouse button switches), and removed the daughterboard with the side buttons. I have also added grip tape to the flat surfaces, so the mouse doesn't just slide away.

The screw holes are a bit delicate, so just be sure to be careful.

You can add your own cable, with less drag, i just didn't have one available.
You can also use your own mouse-feet, as i haven't made any "templates" for mouse feet, but it should work for all of them. I have used G305 feet.

A big thanks to the original creator, as i wanted to do this in the past, but really didn't want to measure everything. Since this is his work, the shell uses all of the original G502 screw holes, and pegs, to make sure it sits as steady as possible.

(My phones camera decided to give up, so the photos are a bit blurry.)

Creality

Ender-3 v2

Doesn't Matter

No

0.12mm

100%