Tired of displaying your GameCube lying flat on a shelf, lifeless and dull? Here's one stand that will make your GameCube come to life.

This stand captures the instant in the boot animation, where the cube dunks down into the center. Frozen in time.

It has been child-tested to be stable enough and won't easily topple, but rather slide instead.

Both the bare and GBP-attached console get their respective stand. Note that they are not interchangeable.

Wired controllers are NOT recommended for obvious reasons. However if you HAVE TO, use a controller extension cable, strain-relief the plug of the extension somewhere, then connect your wired controller to the extension.

Slots for you to attach a velcro band is on the back, making cable management possible.

The stands are compatible with the IKEA LACK wall mount (255mm tall), as shown in the photos.

You MAY use rubber feets under the stand, with the provided grooves. However it's not recommended. Use at your own risk.

The white part is OPTIONAL and personally I don't think it looks good. It fills the gap inside the stand and make the design look thinner, closer to the original design.

Support is recommended. If your support doesn't separate easily, check your slicer settings.

===================
Simlified GameCube "Triforce" Simplified Corner Stand
https://www.thingiverse.com/thing:4736346

===================
You can now buy this from XALT3D from Etsy.

Creality

Ender 3 Pro

No

No

0.2

5%

Use support.

Otherwise pretty simple.