This is a holder optimized for Anycubic Kossel Linear Plus.

Mainboard in this printer is difficult to install and hold, there is a little space between bars and the most of it stay on air and move in annoying way.

This is a simply model to hold it.

I used M3 screw to set it to mainboard and M4 to pin up to structure and for the bar.

I designed and printed it with big square, but when i installed it i saw that wasn´t necessary at all and cut it, V2 is enough.

Anycubic Kossel Plus

Yes

0.2

10/100

100% infill for bars and 10% for square.

I used support for holes.