Summary

A visor to be placed on glasses. For protection against glare in the morning and evening sun, and against wet lenses in light rain.

The parts are divided into three groups.

• visor_main (without raft).stl
  => Visor main body. No supports needed. If printed without raft, the bottom surface is beautiful. The tip of the thin frame has a small plate to prevent warping, so please cut it off after printing.

• temples_mount (with raft).stl
  => Parts to be mounted on the temples of the glasses. Please print with raft.

• springs_for_thin_temples (with raft).stl
• springs_for_medium_temples (with raft).stl
• springs_for_thick_temples (with raft).stl
  => These are plate springs that fits into the mounting parts. for_thin_temples is for temples of about 1mm thickness, for_medium_temples is for about 2mm, and for_thick_temples is for 3mm or more.

Glue the connector pins to the left and right visors in opposite directions, and attach them with a TPU band (recommended) or a rubber band. This will create a folding mechanism.

[Japanese]
眼鏡に乗せるバイザーです。朝日夕日の眩しさ対策や小雨でのレンズ濡れ対策に。

パーツは3グループに分けています。

• visor_main (without raft).stl
  →バイザー本体。サポート無しで印刷してください。また、ラフト無しで印刷すると底面が綺麗です。細いフレームの先端には反り防止の薄いプレートが付いているので、印刷後に切り取ってください。

• temples_mount (with raft).stl
  →眼鏡のつる(テンプル)にマウントするパーツ。ラフトありで印刷してください。

• springs_for_thin_temples (with raft).stl
• springs_for_medium_temples (with raft).stl
• springs_for_thick_temples (with raft).stl
  →マウントパーツにはめ込む板バネです。for_thin_templesは厚み1mm程度のつる(テンプル)、for_medium_templesは2mm程度、for_thick_templesは3mm以上に対応します。

左右のバイザーにはコネクタピンを互い違いに接着して、モビロンバンド(推奨)または輪ゴムでくっつけます。これで折り畳み機構ができます。