Wanted a small test block to primarily test filament appearance & print settings while using minimal filament.

Allows to see the top, bottom, & side surface appearances from various angles.

Tests low sloping angles, over hangs, bridging, top/bottom/side text, etc...

Also has a 3mm hole for testing screw sizing.

Printing with Prusa MK2S Normal settings 0.20mm
layer count: 3 bottom, 3 top, 2 side, 10% infill
0.74meters of filament with 22min print time

Designed on tinkercad, can open there to get measurements or modify if you'd like:
https://www.tinkercad.com/things/1bIReeDrNqe