This thing attaches to the outside of motorcycle chain oil cans, and enables you easily oil the chain with one hand. It splits the oil path from the outlet tube into two and places the oil over the rings where it is supposed to go.

This massively reduces the mess and makes sure that the oil is placed in the correct location rather than being sprayed everywhere.

I have tested this design with both the largest and smallest diameter can that I could find and it works fine with both.

Simply tape the thing onto the can with some strong tape and ensure that the outlet tube feeds into the block with no kinks.

I have tried this with a 530 chain only.

This could be printed with any filament, I used PLA.

Please check my updated models on Printables and Makerworld!
https://www.printables.com/@CADScott/models
https://makerworld.com/en/@CADScott