Compact side holder for headphones/bags, only for desks with a gap between the top part and the legs of the desk.

The model is 10mm high, it would be best if your table has the same 10mm height difference from the legs of the table to the top of the desk.

See pictures on type of desk.

If you need to change the height of the model you can scale it down on the Y axis to your prefered height in your slicer.

I wanted to have my headphones on the side of my table and came up with this simple design. The first iteration had two legs with the gap between them in the exact lenght of the table leg width, that version is more stable and wont wiggle. If you would want that version of the model please reach out to me and I can send you a copy of mine or adjust the dimensions.

Best printed with standard print profile:

-0.2mm layer height

-15% gyroid infill

-no supports needed

IMO: best printed on the side of the model, that way it is sturdier and there isnt a chance of it breaking apart from the layer lines.

You can also print it upright with the base of the model pointing upwards - this will lead to a cleaner finish but the strenght of the object would be compromised a bit. In that case try using better infill density, somewhere around 50% should be good enough.