Surfboard Wall mount.

Credit to Skerks for the design.

Summary from Skerks

This model was originally intended to mount a surfboard on my wall for display. There may be any number of additional uses for it.

-I recommend 25% gyroid infill for adequate strength and stiffness. This creates a stiff print and is sturdy even with the larger surfboard. (20% infill was not enough)

-I used 0.20mm layer height with PETG filament

-Detail is not important so consider using 0.30mm layer height for faster print

-Each mount requires 3 screws

Print Settings

Rafts:

No

Supports:

No

Resolution:

0.20mm

Infill:

25%

Filament material:

PETG