I bought a micro badge maker from eBadges and wanted a holder/stand for it.

There is a rectangular indent for the badge maker itself, a circular indent for the cutter, a vertical slot for the perspex cutting board, and a "box" for accessories/consumables.

It has a dimension of 238mm x 201mm x 124mm, and would fit most standard size printers (not an A1 mini).

I printed it with 10% infill, which took ~340g of filament and 14 hours.

As with any large surface prints, warping is a potential problem. (YMMV, but I find that PETG with a properly heated bed warps less than PLA on a bed slinger.)

I printed mine with PETG but it should work with PLA as well.