Ender 3v3 Plus Front Spool Mount
Zinnorek
Trouver des similitudes avec l'IA
Profil d’impression(0)
Fichier modèle(0)
0
0
0
Publié:2025-08-01 15:14:51
0
0
000Description
Source du modèle
Avis(0)
This is a Front Spool Mount for an Ender 3v3 Plus
Design Concept:
This was for my Print farm I'm starting, and well, the walls are too small to fit more than 20, and I can't have the spool on top because I need to stack them, so to save space. I made this, and I couldn't find one, so I made this.
Design Concept:
This was for my Print farm I'm starting, and well, the walls are too small to fit more than 20, and I can't have the spool on top because I need to stack them, so to save space. I made this, and I couldn't find one, so I made this.
Print Settings:
Ender 3v3 Plus with 20% Infill, .2mm line Height, and this was made in PETG, so let me know if it shrinks with PLA and I can update the mode.
Ender 3v3 Plus with 20% Infill, .2mm line Height, and this was made in PETG, so let me know if it shrinks with PLA and I can update the mode.
Assembly:
You need two M3 X 20mm Screws for the front 2 Screw holes on the front above the mounting bar. Then, screw in the other screws holding the old mount on the side and screw those in to the other holes on the new mount, and then attach the spool to the screws.
You need two M3 X 20mm Screws for the front 2 Screw holes on the front above the mounting bar. Then, screw in the other screws holding the old mount on the side and screw those in to the other holes on the new mount, and then attach the spool to the screws.
Source du modèle
Lien original: Voir les détails
CC-BY