Even with powder snow, you can make a perfect snowman!

Unlike typical snowman molds that can only be used on wet, malleable snow, this mold is designed for any snow conditions—including dry powder snow.

How to use it

If you're using powdered snow, you need to compact it heavily and then add more. Use as much force as possible—the mold can handle it. The mold is easier to demold when it's cold and dry. If your snow is very wet, it won't compact well. It's not feasible to fill each half to the brim by hand, so it's better to overfill and trim off the excess.

Pink snow

1. Fill the two halves of the mold with as much snow as possible
2. Press them firmly together
3. Squeeze each half
4. Repeat steps 1-3

Wet snow

1. Slightly overfill the snow into the two halves of the mold
2. Slide them together from the side and use the edge of the mold to cut off the excess snow
3. Press the two halves firmly together
4. Squeeze each half
5. Repeat steps 1-4

Note: If you use powdered snow, you must compact it thoroughly. Use as much force as possible—the mold can withstand it. The mold is easier to demold when it's cold and dry.

Print

No additional settings are required—just print directly. Use the included print settings. The PETG results are excellent!