The blinking light was a bit distracting. There is no way to turn it off :(
I could have taken it apart and desoldered the light. but something about a warrenty. So I made this knob cover to reduce the light quite a bit.

You can still see it blink, but it's not really noticable, unless you're actively looking at it (see before/after picture).

The design is still the same, just a bit more chunky in order to block most of the light.

The overlap between people with this audio-interface, a 3D-printer AND poeple who are bothered by the blinking led, is probably pretty small...but if it is you, then here you go :)

I designed it for the MiniFuse 1, but the knobs on the MiniFuse 2 look similar sooo it is probably compatible with that one as well.