u/MrGeekman pointed out that I haven't uploaded anything that was just a regular drying stand, so here it is.
It has 5 legs to maximize stability, print it with them facing up away from the bed.
This was designed for full size cases, but is compatible with the Air replacement adapters I designed for Go and Quickshot.

When you use this method of drying it is very important to ensure that the outside of the sleeve and inside of the case are both completely dry before inserting the sleeve into the case, as moisture can get trapped between the case and sleeve, and this can lead to mold growth. To ensure the outside of your sleeve is dry, pat dry with microfiber cloth, or use my triple ring hanger in a well ventilated area for 10-20 minutes prior to using this stand.

Note about case variation:
I noticed that some of my larger cases do not fit into this stand. (ILF has crappy tolerances on their cases) I had forgotten about this fact when designing this thing, if your case is larger than the average full size case, you may need to increase the width and length of this thing by about 1-2mm. If multiple people complain I will upload a second version of this stand that has a larger diameter where the case connects into it. I should have remembered this issue with the official cases, I must have overlooked it when wanting a tighter fit with the average cases.