Based on the Cable Clamp by hulles, extended in length to approximately 160mm (6.3 inches).

I was searching for a locking bar to prevent cables from being pulled through a hole in a project box, or in this case a large container holds a video game system, to deter theft of the controllers and other cables once secured. Because controllers for retro systems use wide plugs, I needed to extend the clamp to ensure it would not be easily pulled through the hole in a container, or ideally an enlarged grommet fitted in the container. Note that these clamps alone will not prevent the controllers from being unplugged from the system with sheer force.

As with the original thing, use M3 screws to hold the pieces together. I printed these in PETG with 100% infill for maximum strength.