The small and cheap GPS Tracker rf-v13 is awesome but as always to get it in a good position can be tricky.

To get some distance between transmitter and magnet i disigned this holder for my garage door protection and glued it.

One version with appr 11mm distance and ohne flat.

• one screw mount
• a USB-cable can still be connected.
• you can put the tracker both ways in
• it will protect the label
• u can close the led side with tape to make it unvisble
• will fit both ways in the holder. One side a little more loose than the other, but to able to use the shocksensor its ok.

No Supports needed thanks to the bridging abilitys of a 3d printer.