I designed this part because I am making my own ender 3 corexy conversion similar to duender, one of the steps I needed was to drill holes at the exact same location on the extrusion, I designed this tool to help me get the extrusions as equal as possible to be able to take the duty of any clamping that would have most likely been used for this task.

PRINT SETTINGS - 

• 3 walls

• 15% gyroid

• 0.2mm layer height

USAGE - 

1. make sure your extrusions are tapped

2. insert a m5x15 screw into the hole on the part

3. insert the extrusion above the screw

4. tighten down the extrusion

COMPATIBILTY -

• compatible with 2020, 2040. versions for 2060 and 2080 coming soon. 

• extrusions MUST be tapped to m5 on at least one end.