Split the box apart so all walls can be printed flat on the build plate with only a couple of snug supports for some overhangs needed for the front slide and back plate. Also added some registration tabs for assembly. Thinned out the bottom and side walls as well so it can be printed at 250% to take up the entire build plate on my P1P. Uses the same roses, top, and latch as the original.

The middle part I had to add a protrusion on due to the thinning of the side walls. When the slider was moved over to unlock to top there was a large gap on the left that this fills in and also prevents it from sliding to the left.