Summary

I had an issue with the original (probably related to my specific LED choice) where the light diffusion wasn't as good as I'd like. I added a small internal dome that sits just above the LED. Printed with fuzzy skin on the dome and outer bulb, the light diffusion is quite a bit more even for me.

My setup:

• Creality Ender 3 V3 SE
• Translucent PLA
• Fuzzy skin on internal face of bulb and internal dome
• 220C first layer, 210C second layer, 65C bed
• 10mm brim for stability/adhesion
• Scarf seam