Bulky, Evil looking crown that holds 30mm, 7.62, and 5.56 shells to complete its design. Fitted to 7 1/2 inch head size, but can be padded to sit higher or fit smaller heads.

You may choose to print projectiles for any of the rounds, I highly recommend doing this for at least the 30mm cannon rounds to make the overall design more pointy. I used the following for the test model: https://www.thingiverse.com/thing:3730354

• Either 1x Full crown print, or 1EA Crown Front, Back, Left, and Right quarters

• Optional, 4x printed 30x173 cannon round projectiles (https://www.thingiverse.com/thing:3730354).

• 4 30x173 cannon shells
• 10 7.62x51 or similar

• 18 5.56x45 or .223 remington

• Padding material for fitting, I recommend using some kind of decently stiff packing foam

• A decently strong 2-part epoxy or JB Weld for assembly

Print either

• Sand the base of all the brass shells, the base of each of the podium

• If printing quarter parts, sand each of the joining pegs and the flat surfaces

• Optional, paint the assembly

• Snap-fit the 4 cannon shells into the largest podiums. Epoxy isn't necessary as these are exceedingly tight snap-fits

• Put a small dab of epoxy on each of the 7.62 shells and glue into the medium podiums

• Repeat for all the 5.56

For fitting, I recommend gluing 4" strips of foam, roughly 1/2" thick along the inside of the ring, then trimming thinner as required.