A handy storage tray for SD cards, screws, nozzles etc. Also a hanger for the filament cutters. The SD card section is angled down and two open slots allows you to easily slide out the cards. There are 2 parts to this print, the tray section and the bottom section.

After printing break the support raft off the bottom section and clean up the slot in the tray section, make sure they fit nicely together then use a little super clue and glue them together. Use some short screws to screw in place. I think there M4 screws.

The are plenty of tool trays out there but nothing that is simple. I just wanted something to store the few items that I regularly use and not clutter up everything with tools and items I rarely need.

Creality

Ender 3 Pro

Yes

Yes

40

Print slow for best results. 25 speed works for me