Holds a Dewalt hand vac and a battery charger and a couple of attachments.

Needs a piece of 20x20 extrusion 500mm long, and has space in the base for weight to be added.  (I used my kid's art clay)

The sockets for the extrusion also have a spot for a heat-set insert if you need to add a grub screw.  However, after printing I found that the extrusion was snug enough and isn't coming out without quite a bit of force.

The top part needs support for the charger cable channel on the back.  I found my design to be sub-standard here as the cord turns the corner to go down the extrusion as the design doesn't match how the cord can actually bend.

The bottom part needs support for the 2mm recessed lip around the hollow space, but the compartments should be fine with bridging.

Printed on a Bambu H2D, so size-wise might be difficult with smaller printbeds.

A carry/grab handle on the top might be good addition.