I use this thing to run steppers with the pulse signal generator from MKS :


This gadget is a great way to run stepper endlessly and straightforward, for my Filament Winder.
The enclosure is to fit :
- 1x MKS Stepper Pulse Signal Generator (it's everywhere)
- 1x Meanwell LRS 150-24 Power Supply (usually other clones have similar footprint)
- 1x DM542 Stepper Driver (can drive nearly any stepper reliably, great torque)
- 1x AC Socket

Fasteners required :
- 2x M3x8 (PSU)
- 4x M3x8 (Control Board)
- 4x M3 Nut (Control Board)
- 2x M5x10 (Stepper Driver)
- 2x M5 Nut (Stepper Driver)
- 2x M3x10 (AC Socket)
- 2x M3 Nut (AC Socket)
- 2x M3x20 (Lid hinge)

The bolt locations are quite straightforward and these screw lengths are not mandatory. You can do anything to get them to mount :) they are just holes in the box. No heat set inserts required.
 

Wiring them is easily looked up on the internet but if anyone wants it I can guide you in the comments.