Pumpkin Dispenser
Varoren05
Encuentre similares con IA
Perfil de impresión(0)
Archivo de modelo(0)
0
0
0
Publicado:2025-12-07 08:43:46
0
0
000Descripción
Etiquetas
Fuente del modelo
Comentarios(0)
This model was developed for a more playful Halloween experience, designed to dispense treats from the pumpkin's mouth when pressure is applied to the top. The model is divided into five parts: the pumpkin, which contains the spring and serves as the overall exterior appearance; the base, which attaches to the storage compartment to prevent treats from escaping; the storage compartment, which holds the candy on an inclined plane; and the top, which consists of the stem and a small bowl used for decoration and to conceal the spring. Each piece should be printed individually and assembled in the following order: attach the base to the storage compartment, glue the bottom of the spring inside the "pumpkin," and glue the stem to the bowl, then attach both to the top of the spring.
Etiquetas
Fuente del modelo
Enlace original: Ver detalles
CC BY