Project: r2d2e.hfp

Print with a layer height of 0.08 mm and a base layer thickness of 0.16 mm, and a 100% infill rate

The model size is 150x150mm.

You can print with a higher layer height, but it cannot be lower than the minimum layer height of 0.24mm.

The maximum layer height is 2mm, and the actual layer height is also 2mm

Consumables used:

PETG JAYO Black, Distance: 0.3

PLA+ Sunlu red, distance: 3.6

PLA+ Esun Space Blue. Distance: 3.5

PETG JAYO White, Distance: 6

This print uses four different consumables

!!!! It seems that you're using different types of consumables together. Please make sure that this is the effect you want to achieve. !!!!!

Replacement Guide:

It all started with black

Replace it with red at the 11th layer

Replace it with space blue at the 14th layer

The remaining part is made using white consumables.