It's summer time in Norway, and I decided to repair the handle of the crank to close the shutters on my balcony.

This replacement handle is made of several parts:

• the handle, which you should print twice
• the "clip", which you should print once

The clip goes around the shaft. It should be able to rotate but not to move vertically. I had to put the clip in hot water (~100 degC) for one minute to be able to install it.

I recommend putting neoprene glue on the edges to assemble the whole thing. Other types of glue might work, though.

The clip should maintain the handle in place.

With my best wishes for a sunny summer!

Printed in PLA on a Replicator 2 with the following parameters:
0.30mm layers with 15% infill.

Took 1 hour and 20 minutes to print.