Replacement for the original injection moulded ABS power/ mode button. The print fits snug with zero wiggle room or rattle, the print sits very close to flush with the remote casing once installed. Installation is as simple as unscrewing the two half of the controller, placing the deadman's trigger and thumb wheel aside then unscrewing the motherboard from the casing, replace the power/ mode button and reassemble. If the circular indent on the bottom is vanishing after slicing try disabling 'union overlapping volumes' under the mesh fixes tab within cura (or your slicers equivalent setting). I suggest printing upside down to avoid a bridging layer that would otherwise be needed around layer 11ish.

If anyone does end up printing this please post a make, I would love to see : )

Category: R/C Vehicles