Versions:

• There are two versions, A and B. Depending on the printer and the filament you are using, a version may work better than another, but they both function the same.
• Version A:
  • Recommended to print with 100% infill, without suport
  • Includes zip-tie tie down point for cable strain relief
  • Ambidextrous, you can choose which side the cable comes out
  • Easier to install, but holds the controller less securely, might dislodge during excessive active movements
  • Assembly:
• Version B:
  • Recommended to print with 100% infill, with suport
  • Includes zip-tie tie down point for cable strain relief
  • Ambidextrous, you can choose which side the cable comes out
  • Holds the controller more securely, but requires a bit more force and dexterity to install.
  • Assembly:

Mounting:

• The mount can be mounted to any GoPro mounts that have three prongs.
• If you wish to wear the Leap Motion controller on your neck, you can check out the GoPro neck mounts I published:
  • GoPro neck mount
  • Customizable GoPro neck mount
• If you wish to mount the Leap Motion controller on a mic arm, you can check out the GoPro mic arm mount I published:
  • GoPro to 3/8" mic arm adapter