Book/Ring binder in A5 format for SMD and THT resistors organising. Left part contains small values for all SMD sizes and 5 sizes of THT resistors. Right side is for larger values but dimensions not smaller than 0805 (they can mix between windows).

• 0,4mm nozzle Creality K1C
• PageRight.stl and PageLeft.stl 15% infill, 0,16mm layer (variable layer hight advised, lower part can go up to 0,25mm)
• The rest 40% infill, 0,2mm layer

Make sure to use hot air gun after print to get rid of tiny threads.

If pin.stl falls off too easily from lit.stl, use glue.

When inserting lit.stl into PageRight.stl or PageLeft.stl, small threads might come loose. Remove them with tweezers, knife or pliers.

Resistors should not leak from windows, but avoid sharp manipulation with the book.