An ultra-thin (0.4mm) Macbook camera cover that's only one perimeter thick. It still fully blocks the camera!

This is a remix of https://www.printables.com/model/913267-macbook-camera-cover-parameterized

The original model was quite thick and it didn't allow the lid to fully close, so I remixed it to make it as thin as a common nozzle can make it. By tweaking the Fusion 360 file it can be made even thinner to work with smaller nozzles.

To print it: enable the brim and print it while standing on the small side, sideways. It should be easy to remove any stringing artifacts with a sharp blade. If it slides sideways too much you can warm up your heated bed to 60-70°, place it on it on its side and push on it to deform it slightly.