I am using this simple cable guide to prevent snags on the heated bed cable, to pair with the Cable Support remixed by Elphwrkz. 

This is designed to replace the stock internal filament guide secured by 4 screws, just remove and replace. 

I am only able to test this on my Qidi X-Max, but it may fit other Qidi printers. 

The “E” was added for some personality, a no letter options is available also, if you want a different letter let me know in the comments. 

Materials:
I am trying this out in Sunlu PETG, which should be fine for low temp printing, but will most likely reprint in Polycarbonate when I am upgrading to the Icarus 2.

Print Settings I used:
0.4mm Nozzle
0.2mm Layer Height
50% Infill (Anything from 20% should work fine)