After relocating the Ender 3 Electronics to the back of the device, I moved the display to top of the old electronics box. This trimmed about four inches from the width of the printer.

Pick your material carefully and remember that this part will absorb lots of heat from being mounted under the bed.

I do not know how the excess heat will impact the display, so use at your own risk!

Print instructions

This is a very simple print, designed to accommodate a filament color swap to color the logos.

When removing the print, be careful as PETG is brittle and can break. Remove it slowly to prevent the part from breaking as well as damaging your bed (PEI users specifically).