First layer leveling or Z-layer adhesion test for the Ender-3 V3 KE.
Don't forget to use automatic calibration for printing!
When you load an image, Creality Print will automatically scale it to 90.00%, but please manually scale it back to 100.00% as shown in the figure, as this is the maximum print area of 22x22cm. The layer height is 0.2mm.

I added two more pictures under "Printing" and "Completed"
Setting: Hyper-PLA white, first layer speed 200mm/s, acceleration 800mm/s2, first layer idle speed 300mm/s, acceleration 1000mm/s2.
According to my settings, it takes 23 minutes

You can also see my Bed Mesh, which is terrible. You can access it in the browser by adding the printer's IP address to https://. It's located in the lower-right corner. Just scroll down a bit