A stand for a Waveshare - 4.3 inch DSI Touchscreen

It has a tight fit, requires decent bridging capabilities of your printer and should not be printed above 0.2 layer hight due to the overhangs.

Edit: I'm not really proud of the back/cover, especially not with the mounting, but after a comment I uploaded what I'm using so far. Never was a priority to further improve ;)

Uploaded the main part "PiScreenCase_Waveshare-4.3DSILCD_vBack v11" which only has an additional hole for the ugly mounting of the back cover with a single screw ;)

Print Settings

Rafts:

No

Supports:

Resolution:

~0.1-0.2

Infill:

Notes:

• Support from build plate

Category: Electronics