I wanted a turn table to use with my new air brush so I made this one to work with a random bearing I had laying around.

The bearings dimensions are 25mm dia down to 22mm osd and isd of 7.75mm. standing 7mm tall the lip is 1.45mm of that total.

printed with some old pla i had laying around with 5% infill because its just to hold pieces while painting no heavy work intended.

I made the holes a little big and hot glued the parts in place so that I can remove them later on if I decide to print the fancy one with curves that I have uploaded.

Also, unlike the picture all the holes are the same in the released version.