This is a remix of a lid for https://www.printables.com/cs/model/72243-tic-tac-cap-a-game-of-stacking-and-stealing . 

I did not want to bother with steep overhangs of the original model, so I did this remix. 

Used a modifier box to set number of top and bottom layers to 0, so I get nice honeycomb pattern and see through lid.

Onfortunatelly it was tiny bit loose when printed, is a rubber band to keep lid and board together.

Printed with 0.2 layer width, extrusion set to 0.6mm so the walls of the lid are printed with lower number of passes.