NEW UPDATE:
I've created a new model 'NEW_Weeping_angel_tree_topper_with_hole.stl' that is hollowed & has a hole in the bottom, so you do not need to cut the hole after printing. You should be able to print the new model similar to the old one. No Supports.

Original File & Description:
I remixed this from the original using meshmixer, in order to accommodate use as a tree topper.

I recommend .2 layers, but this was printed at .28 layers, 0% Infill, 3 top layers, 5 bottom layers & 4 perimeters (using a .4 nozzle). A hole was then cut into the bottom using a hole saw bit (which will be drilled further to hold LED's).

*TIP: When drilling the hole be careful! Once the guide bit punches through, you can run the drill backwards to gently cut the hole through the plastic

NO Supports needed!

WARNING: Wives & small children may not be amused! :)

Creality

Ender 2

No

No

.28

0%