I swear I was going somewhere with this. Was suppose to be a small part of something bigger but projects on top of projects got in the way and it ended up collecting dust.

So now, it's an open-source abandoned project that someone can hopefully adopt. I'd hate to have all that work go to waste so it's the least I can do with it.

Going to upload the .SVG, .STL, and the .STP to make it a TRULY open-source design. Have at it!

No

No

200

20

Have not printed this but i'm quite certain it should print just fine with no issues. It's all one piece, small 2mm bridges on the bottom will hold it all together. Just remove carefully from the build plate. There should be no issues with editing the dimensions in your slicer. No supports needed.