Mount for hand held tape dispensers so that you can grab them off the wall quickly.

Started out trying one of the parametric Multiconnect item holders, but had issues with the tape hanging off the dispenser getting stuck to things.

Decided to create a new model from scratch that works better:

• Put in a hole for the tape to pass through
• Angled support from underneath so that the part could be reoriented to print for additional strength

Uses only a single Multiconnect rail so it should work as-is with a set of 2 Multiconnect snaps on either openGrid or Multiboard.

Could probably shave off a few mm on the left / right.