I was looking for a simple gift card box and nothing met my needs entirely so I designed my own.  No supports necessary.  No raft or brim needed when printed properly on a well-prepared build sheet.  If you struggle with bed adhesion, you may want to use a raft for the bow components.  It fits a gift card diagonally but obviously can hold whatever you'd like to put in it.

Try different infill patterns to add some interest to the top and bottom of the box!  These look especially nice with metallic filaments.  In my pictures, I used Prusament Mystic Green and Viva La Bronze PLA on a smooth PEI build sheet.  If you are using Bambu Studio, navigate to “Strength” and go to the “Top/bottom shells” section.  Change “Bottom surface pattern” to anything you would like to give the desired effect.  Hilbert Curve and Octagram Spiral can produce some fun results.  You can also change the “Top surface pattern”, but it will only be viewed on the insides of the box and lid.

I designed this for the bow to fit very snugly over the box and lid.  This prints and fits really well on my printer, however you may need to adjust scale on either the box & lid or bow components by +/- 1% or so if you find the parts to fit too tightly.  If you print in PLA, the bow parts will stretch a bit if they are installed and left to rest.

If you Would like to send a tip:

Venmo: @Dave-Sauvageau

Paypal: davesauvageau@yahoo.com