UPDATE: December 2025

This thing needs a TON of work, I'm not sure the original was properly drawn out. My first print attempt resulted in pieces that would NOT go together. If I get some time, I'll redraw this, but I wouldn't recommend printing this.

I needed something a little different, but the AD5X Base Stand Riser by Psyk0 was a great place to start. I needed adjustable feet. So I extended the 4 corner pieces 10mm and added a 23mm threaded hole in the bottom for an adjustable foot - see the STL files. This is still very much a WIP. I'm leaving the side and back pieces the same height, but I know I have to do something with the drawer piece. Once I get that figured out, I'll upload that. I'll probably make the keyway go all of the way thru on A & D where the drawer slides in , and make a filler piece slide in on top f the drawer.

I plan on printing it this weekend, and will update any changes I make then.