men's wallet printed on ad5m in petg I'm sure any other filament will work.

if you need it to be easier to hold in place print at 15mm height instead of 10mm keep in mind the extra height may get in the way of the blade.

to assemble you'll need two of both the wallet card body and the inner pocket you don't need to 3d print two of the inner pockets. 

sew the inner pockets either side on the inner portion of the leather first, then one pocket on the opposite side facing up, then the last pocket again facing up on the outside (same side as the inner pockets).

for the inside inner pocket only stich 2/3 of the way up to the stich is not visible from the outside.

please feel free to remix, post photos, comments or questions.

thanks.

-G.B.-