This makeup brush drying rack was made by me using Tinkercad. I hope you'll like it!

It can accommodate 1-3 makeup brushes

The bottom of the makeup brush is suspended in the air, allowing it to dry in the air and preventing water from accumulating and causing mold.

It is printed using PLA material.

The floor height is 0.12mm.

The filling rate is 100%.

There are four grooves at the bottom, which is convenient for placing IKEA anti-scratch pads and enhances the texture:https://www.ikea.com/se/en/p/fixa-stick-on-floor-protectors-set-of-20-grey-00431151/